Summarizing how the gadget function

Cube world set is an electronic gadget that function with power that supplied by battery. This cube built by parts such as electric plant, speaker, buttons, and screen. this parts are connected with each other by electric current. When the cube is manage singular,its buttons may direct use to control the stick man inside. However, a set of more than one cube will built their ownworld such when the signal detected through the magnetic ports by sides of the cube. With this signal, the stick man in the neighbour cube can automatically communicate with each other or can transfer itself to the next cube. Therefore, cube world set overall was run by the electric power to sent and accept electric pulse as a signal to communicate with each other throught magnetic ports by the sides. For a clear connection between cubes, the magnetic ports must stick on the right site of cube.

Final assessment

product exhibition : Hair dryer

Main part ; The motor

Hair Dryer Air Flow

The small motor actually sits inside the fan, which is firmly attached to the tip of the motor. When supplied with power, the motor and the attached fan both spin. The centrifugal movement of the fan blades draws air in through the small round air inlets in the side casing of the hair dryer. These holes are covered by a safety screen that prevents other objects from being sucked in as well. The air is then blown down the barrel of the hair dryer.
The small black fan sits atop the motor. The motor spins the fan. Air is drawn in through the openings on the side of the hair dryer.
This hair dryer have high and low airflow settings.Changing the airflow involves modulating the speed at which the motor is turning. This is accomplished very simply by altering the current flowing through the part of the circuit feeding the motor. When the power supplied is low, the motor and the fan spin slowly. Less air is pushed through the hair dryer. With more power, the motor speeds up. The fan rotates rapidly, drawing in more air and increasing the airflow.

Describing main/major and minor parts or component

Main part 1 : Buttons

There are four main buttons are available to control the cube. There are:
1.SOUND - This button will allow you to turn the soundON and OFF.

2. ON / STICK GAME / GAME CONTROL – Pressingthis button will turn ON the cube. Once the cube ison, pressing this button will start the GAME MODE.Once in GAME MODE, press this button a second timeto start the GAME. Once the GAME begins, you CONTROLthe movement of the STICK CHARACTER bypressing this button.

3.RESET – Insert a blunt point into the RESET BUTTONto reset the game settings. This button is located onthe back of the cube.

4.RESET – Insert a blunt point into the RESET BUTTONto reset the game settings. This button is located onthe back of the cube.

To on the cube set, buttons are set to start it. It was located on every sides of the cube. Each ports of the cubes are connected in sequence. These enables the cube to interact with each other. The ports are connected via magnetic force. The ports of the cube are very flexible because we can place any cube at any side of another cube. It can be arrange horizontally or vertically. The cube are transfer the signal to the other cube that connected with it via electric charge that can flow through the magnetic ports. The power of these cubes are supplied by one (1) CR2032 battery. To insert battery, using a screwdriver, loosen the screw until the battery compartment door can be removed. Then,insert One (1) CR2032 battery as indicated inside the battery compartment. Lastky,replace the battery compartment door and tighten the screw with a screwdriver. Do not over-tighten.